MECCANICA e DINTORNI

Hi Tasos :I dont' understand the plate that you need because the plate in foto is not engraved ,I suppose that is only the cover of norton box.

CARLINO ha scritto:Hi Tasos :I dont' understand the plate that you need because the plate in foto is not engraved ,I suppose that is only the cover of norton box.

in my tornio the cover have the feeds and speeds for diameter and threats.. but the numbers have deleted by the use

look closer the next photo

That position is very bad for a table , is better a vertical layout : I think will be very difficult to find a photo of this table...

hi again

finally i found a friend of friend how had the same gearbox with clean table on bigger tornio named ARIS !!!

please can anyone tell me what set up is for metric threats ???? because the table is Italian language.

thank you in adnvance guys




http://meccanicaedintorni.morpel.it/php ... w&id=77562

http://meccanicaedintorni.morpel.it/php ... w&id=77561

I don't know if this lathe have the same gear box : probabily external box is the same but inside the gear could be different. The first photo have the metric thread up and down Withworth, the second (the first part of plate )have a strange indication : diametral, modulo, decimali and I don't know if the numbers are pitchs or not.

taso tha ithela diastasis gia ta granazia 30 kai 95 exoteriki diametro akribos to mono gnosto einai to mondul 1.75

ean o filos ta exei na mas eukolini gia na kano nea giati mou lipoun

Adesso scrivono anche in greco....

sono i compagni di campeggio di albarello...

Logarismòs , parakalò . . . .

Λογαρισμως ,παραkαλο....
Mario , almeno usa l'alfabeto giusto.....

si prega di diametro per ingranaggi 30 e 95 modulo 1.75 tornio aris

Grazie in anticipo